Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Code not re-compiling
I'm integrating live++ into a project and I'm able to properly load live++. My issue comes from the fact that code is not being re-compiled when I change something.
I assume it has to do with the fact that there are no translation units. (I would show an image of the log but images seem to be broken).

Is there usually a specific reason as to why this happens? I'm not able to find any info on this anywhere.
Apologies for the late reply, seems email notifications weren't set up properly.

Regarding your question: please make sure that /DEBUG:FULL is enabled in the linker settings (/DEBUG:FASTLINK is not supported).
You can also turn on "Enable Dev output" and "Enable Dev compiland output" under "Logging", so Live++ will log where it tries to find the object file for each translation unit/compiland.
Make sure these files are available on your machine.

If you want, you can also send the dev log file to and I'll take a look.

Forum Jump:

Users browsing this thread: 2 Guest(s)